View A5016_1204612.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

DESIGN SHOWCASE
Standby current for RS-422 repeater is less than 3A
The RS-422 interface is an excellent choice for communicating in noisy environments and over a distance. However, when the distance exceeds the RS-422 capability for reliable data transfer, you must add a repeater. The repeater circuit in Figure 1, which must operate from batteries when no power supply is available, draws less than 3A of current from a 3V supply. Low standby power and true fail-safe operation are the key features in this application. U1 and U2 drive their receiver outputs (RO) high when the RS-422 inputs are open circuited or terminated and undriven. An incoming data byte on the differential inputs A1 and B1 forces a transition on RO of U1, and a state machine (right half of the Figure 1 schematic) is latched ON by the falling edge of RO. The state machine asserts a high level at U2's driver-enable pin, causing the incoming data byte to be retransmitted from U2 at full RS-422 levels. The state machine watches for transitions on RO. When a data-byte transfer is complete (as indicated by no falling edges within a time delay internal to the state machine), the state machine resets itself in anticipation of the next data byte from either side of the interface. An incoming data burst (Figure 2, top) is retransmitted as outputs A2 (bottom trace) and B2 (middle trace). U2 de-asserts those outputs 700s after the final transition. Other delays can be implemented by adjusting R1/C1 and R2/C2 as shown in Figure 1.
VCC D1 1N4148 R1 4.7M C1 220pF 8 7 R3 120 A1 6 5 VCC B A GND U1 RO RE DE DI 1 2 3 4 1 2 U3B 74HC00 4 5 6
VCC C3 100nF B1
1 CLK D VCC CLR PRE 4 10 U3C 74HC00 8 D CLK PRE CLR 13 11 12 11 Q Q U4B 74HC74 9 8 3 U3A 74HC00 3 2 Q Q 6 5 U4A 74HC74
MAX3471
GND1 VCC 9 10
GND2
C4 100nF
8 7
VCC B A GND
U2
RO RE DE DI
1 2 3
B2 R4 120 A2
MAX3471
6 5
VCC 4 D2 1N4148 R2 12 4.7M 13 C2 220pF U3D 74HC00
Figure 1. This RS-422 repeater draws only 3A of standby current.
16
Figure 2. An input data byte causes the repeater to transmit the byte, then go to standby. Vertical scale is 1V per division; horizontal scale is 400s per division.
(dB)
17

▲Up To Search▲

Price & Availability of A5016

	To Download A5016 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .